Hello Guys,
I am very new to sccm 2012 and it seems I have hit a stow stopper when installing Client
In my test lab i have one machine Server 2008 R2 hosting SCCM, SQL Server and DC. I only have one machine (no separate machine for client) so I need to learn using this only. Machine has 4 processors and 16 GB RAM. So H/W is not that bad.
Installed all the above three components and when tried to install the client on this machine I have only TWO actions listed. This client has not sent its H/W and S/W inventory too.
I have configured to use boundary IP range from 192.168.0.0 to 192.168.254.254
Client machine in my case is also the domain controller. :(
I have tried to install it from Command prompt using CCMSETUP.EXE and from the GUI using Client installation.
CCMSetup.log has no errors and it says client is installed. The Site is assigned in the config mgr applet. and it also picks up the site if i try to find/configure it again.
I am really stuck, uninstalled sccm , client couple of times.
Rebooted machine several times. Still no luck.
Help me Guys.